All About Lube Oil Change And How To Do It Right
Getting your lube oil change is something we all must do. How to do it right, is something that not all of us will accomplish. Hopefully with a little insight, you’ll know a bit more about this job and attempting it yourself may become a valid choice.
The first step to performing this task is to gather the required materials you’ll need.
The proper amount and grade of motor oil for one. We’ll need an oil filter that fits the car or truck. A good drain pan, to catch the old oil. It’s important to make sure you have everything you need especially if your about to work on the only ride you have to the auto parts store.
Having your oil changed and a lube job from a service station or garage, will usually be so inexpensive that it makes doing the job yourself slightly less attractive then in the past when prices where much higher for this type of service.
It’s a dirty job and the companies out there that offer such low prices, are the ones to get to do it.
They can supply oil and filter so economically because they buy huge amounts from suppliers and get a substantial discount over the cost of the same materials for the general public, who’s buying one oil change at a time at retail rates. This is one reason they can do this job so cheap.
Another issue you’ll face when you tackle your own service work is disposing of the old oil. Service stations often burn the used oil in a waste oil burner and thus disposal cost is negated for them further reducing their overhead which they in turn can pass on to the consumer.
Oil changes are pretty cut and dry.
You’ll raise the vehicle with a jack. Then using jack stands for safety, remove the plug from the oil pan under the engine and drain the oil into your drain pan. It helps to open the fill cap on top to vent the engine. This will help get the oil to completely drain.
Next you’ll use an oil filter wrench of the proper size to remove the old oil filter.
Watch out for residual oil that will remain in the filter, even after draining the engine.
Tipping the old filter as you remove it will lose this residual oil all over the place if caution is not used with this stage.
Next use a small amount of oil and rub a coat on the gasket of your new filter before installing it. This helps to lubricate the gasket to prevent it from dislodging from it’s seat when installing. Tighten the oil filter hand tight and then a half turn with the oil filter wrench.
Replace the plug in the pan and tighten with a the proper size open end, box end wrench, or socket.
Once we get to this stage it’s time to add the proper amount and type of oil to refill the engine.
How to get your lube oil change and how to do it right, will also include getting any lubrication points lubed with a grease gun. All ports should be filled until they show overflow.
Lube Oil Change,Easy Lube Oil Change,Fast Change Lube & Oil,Speedy Lube Oil Change,Super Lube Oil Change
Like this post? Subscribe to my RSS feed and get loads more!